This is the right place if you are looking for the error codes of Videocon Air conditioners. All the Videocon air conditioner error codes are given below in a table with their meanings and marks.
Videocon AC Error Codes With Their Meanings
| ERROR CODES
|
MEANINGS
|
MARKS
|
|||
| E0 | Open the door fault | Blinking 3 times/ 8s | |||
| “df” or heat icon flashing | Defrost | Blinking 1 time/1s | |||
| E1 | Outdoor tube temperature sensor problem | Blinking 4 times/ 8s | |||
| E2 | Room temperature sensor problem | Blinking 1 time/ 8s | |||
| E3 | Fault in Coil temperature sensor | Blinking 2 times / 8s | |||
| E5 | Indoor fan problem | Blinking 6 times/ 8s | |||
| E6 | (EEPROM) Failed communication | Blinking 6 times/ 8s | |||
| E7 | External feedback problem | Blinking 7 times/ 8s | |||
| E8 | Overheat protection/ Defrosting | Blinking 3 times/ 8s |
What are the possible reasons for the Videocon Air conditioner error codes?
The most likely reasons for the error codes in Videocon air conditioners are:
Poor Sensors
Faulty Wiring
PCB boards problem
- Also, after seeing the errors in AC, one should check all the sensors thoroughly to confirm if any of them are malfunctioning.
- The PCB boards are the computer boards that are used for controlling the mini-split.
- The bad PCB produces errors in reading the proper feedback related to the voltage from the sensors.
Note: The above-mentioned self-check information is generally applicable to most of the air conditioners by Videocon. But some might be special and you should refer to the User’s manual for more information to do contact to authorized maintenance serviceman or your dealer for help.
How to troubleshoot the above-mentioned error codes?
- First, check all the sensor wiring to confirm that all of them are working fine.
- To troubleshoot a unit, you should know the location of different sensors.
- The information related to the location of units is available in the user manual as well.
- Also, test the resistance of each sensor.
- In the case when the testing of sensors and wiring are showing good, most probably the PCB board has gone bad.
Read More-
